Sales consultants · Follow up systems
Follow up after the proposal, the recovery and the introduction, or the work goes quiet.
A follow-up system for a sales consultant is a set of written next steps for each moment that goes silent: after a proposal, after a diagnostic, after an introduction and after a recovery. GullySales drafts the messages and the reminders so that each stage has an owner.
Scope, fee, reporting and term are agreed in writing after we have read your brief and spoken to you.

What follow up systems means
A follow-up system is the set routine for calling, messaging or emailing an enquiry more than once, since most buyers do not decide on the first conversation. GullySales sets the number and timing of follow-ups so an undecided buyer keeps hearing from you until they decide either way.
Last updated 14 Nov 2026.
For sales consultants
Where it usually goes wrong, and what we would do.
“A good diagnostic call ends in silence”
The sales head says it was helpful and then the quarter-end review absorbs them. Without a dated next step agreed on the call, the enquiry goes cold without anyone deciding it should.
“The sale you made is the one you forget”
When numbers recover, the client stops calling. A check-in after the recovery, asking what the team has kept, is when the next piece of work or the next introduction appears.
“Advisers need to hear back”
An auditor who suggested you wants to know the client called. A short update, with the client's agreement, keeps that adviser sending work.
“A proposal needs a smaller option attached”
A year-long proposal stalls because it cannot be approved at once. A smaller option in the same document gives the sales head something to approve while the larger scope waits for the board.
What we do
What we deliver for sales consultants.
The work available for this need. We agree the deliverables and responsibilities for your engagement in writing.
A map of silent moments
A list of the points where an enquiry goes quiet, such as after a first call or a sent scope.
Result: Each point has a named next step and a person responsible.
Message templates for each moment
Short drafts in your voice for the post-call note, the proposal nudge, the thank-you to an adviser and the check-in.
Result: Each message references the specific conversation, not a general greeting.
Reminders in your tool
Dated tasks set at the time of each call, held in the CRM or calendar you already use.
Result: You see on your own screen every conversation that is waiting.
A past-client check-in plan
A list of clients whose numbers recovered, with a reason to write to each and a short review offered.
Result: Each past client receives a message tied to what they achieved.
A proposal with a small option
A scope document with a short first piece and a separate larger option, both priced by you.
Result: The buyer can approve the first piece without approving the whole.
How the result is measured
- Follow-up completion rate
- Average number of follow-ups before close
- Enquiries closed after repeat follow-up
Recorded as a baseline before work starts, so every later report has an honest comparison.
What to capture or send
Decide in advance what to send at each silence.
- After the diagnostic call
- Send a one-page summary of what you heard and the first piece of work. Record whether the buyer replied.
- After the proposal
- Ask one specific question about the scope, and attach the smaller option. Note which option the buyer picks.
- After an adviser's introduction
- Tell the adviser the introduction was received and what happens next, without giving client detail. Record the reply.
- After an engagement ends
- Offer a short review of what has changed. Log the date so the check-in is not left to memory.
- When the sales head goes quiet
- A short note with one useful question, not a reminder. Record when to stop and who decides.
Who it is for
This is written for these sales consultants.
- Sales process and pipeline consultants for B2B companies
- Field sales and distribution consultants for FMCG and consumer durables
- Consultants for dealer and channel partner sales
- Sales team structure and incentive design advisers
- Sales coaches working with managers and top performers
- Consultants for technology and software sales teams
- Export and institutional sales advisers
- Former sales heads who now consult for a few clients at a time
Before you decide
When this may not be the right fit.
- You have not yet written a proposal with a smaller option, so a follow-up would have nothing new to offer.
- You cannot reply to a senior buyer's answer the same day, and a nudge would only invite a conversation you cannot hold.
- You want messages sent automatically to the managing director, who will notice and dislike it.
Before you decide
Agree the work. Know how to judge it.
Follow-up systems for sales consultants: use these checks to prepare, choose the scope, and review what changes.
Bring the right evidence
Trace recent enquiries from arrival to the last recorded action. Include a won enquiry, an unsuitable one, and one that went quiet, with personal details removed for the initial discussion.
Make the scope clear
Agree who accepts each enquiry, what makes it qualified, and how ownership changes. Include a rule for missed replies and a clear reason for closing an enquiry.
Check the work in use
Pick an enquiry at random and ask the team to find its owner, latest conversation, and next action. Check that the record agrees with what actually happened.
Know when to change course
If no one has capacity to respond, assign that responsibility before buying more leads. Automation can support the owner, but it cannot replace an unresolved handover.
These are discussion points, not a fixed package. GullySales confirms the deliverables, responsibilities, fee, and term in writing after reading your brief and speaking with you.
Before we start
What to have ready before the work starts.
The records, access and decisions this work needs from sales consultants. Anything missing is noted in the written scope, with who will supply it.
- Sent mail for the last year
- We need access to proposals and the messages that followed, or an export of them. Names can be covered. This shows the real pattern of what you send and when you stop. If it is unavailable, we draft the system from your memory and mark that the messages are untested against your own habits.
- A list of open proposals today
- Write each live proposal with the buyer's role, the date sent and the last contact. We use it to run the first messages on real cases. Without it the system starts from nothing, and the first weeks cannot be compared with anything you recorded, so you could not say afterwards which messages woke a buyer and which were ignored.
- Your rule on closing a quiet proposal
- Decide how long you will wait and what you say when you stop. Only you can say what feels respectful to your buyers. If you leave it open, reminders keep arriving for conversations that are already dead, and the system feels like nagging.
- Contacts of advisers who introduced work
- Advisers need to hear back about the person they suggested. Bring the names and what happened to each introduction. If the list is missing, the adviser messages cannot be written, and the people who send you work hear nothing back about the person they named, which makes a second introduction less likely.
- A list of past clients to check in on
- The sale you made is the one you forget. Write the clients who have not heard from you since the engagement closed, and whether a note is welcome. Without the list, the check-in plan stays blank and the easiest repeat work goes unasked.
How it works
How the follow up systems work runs
The work itself, in order. How an engagement starts, from your brief to a written scope, is set out on our method page.
- 1
Find where past conversations went quiet
We go through your sent mail and phone log for the last year and mark each place a conversation stopped: after a proposal, after a diagnostic, after an introduction, after a finished engagement. You tell us which silences you understood and which you still wonder about, so we know where to look first.
- 2
Write down what silence meant
For each silent moment we ask what the buyer may have been doing: waiting for a board, comparing a course, asking an adviser, hoping the problem would pass. You say how each ended when it did revive. From this we decide what a next step should offer that the earlier message did not.
- 3
Decide when you let a conversation go
A follow-up system needs an end. With you we set the rule for when a silent proposal is closed, how the closing message reads and who is told. You choose how a senior buyer is approached after a pause. A respectful close can bring an answer that a fifth reminder would not.
- 4
Draft the messages and the smaller option
We write a message for each silent moment in your voice, with a question the buyer can answer in one line. Each proposal gets a smaller alternative attached, so a hesitant owner can say yes to part. You read each draft aloud and change any line you would not send to a managing director.
- 5
Put the reminders in your tool
The reminders are set in the tool you already open, tied to the stages, with the draft message attached to each one. We test them on three live conversations. You tell us which reminder arrived at a bad moment or asked for something you do not do, and we change the rule rather than your habits.
- 6
Read what came back against the start
Before the system runs, we record how many proposals and diagnostics were open and how many had no reply. Later we read the same figures after the new messages have been used. You see which silent moment woke the greatest number of conversations. We do not promise replies; we show the difference against the record.
Where this fits
Three pieces of sales work, in this order.
This work sits inside sales process design, at stage 2, qualification. The audit comes before it, and sales management keeps it running.
Step 1
Sales audit
Find where deals are being lost and what to fix first.
Start here if you cannot say where orders are lost.
Step 2 · you are here
Sales process design
One written way to sell, from first enquiry to repeat order.
Start here if every salesperson sells differently.
Step 3
Sales management
A target, a review routine and someone who owns the number.
Start here if the team has targets and no routine.
FAQ
Questions owners ask before they call.
Not here? More answers, or ask on WhatsApp.
How firm should a follow-up be with a senior buyer?
When do we stop following up?
Can follow-up be automated?
Can a managing director be followed up without pressure?
Can follow-up reminders go to an assistant?
What if a buyer says they are no longer interested?
How much does it cost?
How long is the contract?
How soon will we see results?
Who will actually do the work?
More for sales consultants
Related work to consider.
Closest to this: leads and follow-up
Also for sales consultants
Or start from the overview: sales and marketing for sales consultants.
Your next practical step
Tell us what you are trying to grow, and we will read it before we call.
Eight short steps, mostly taps. Skip anything you would rather answer on the call.