Skip to content
GullySales

Electricians · Follow up systems

Follow up each quote so a silent customer gets one more helpful nudge.

A follow-up system for an electrician is a set routine for what you send after an enquiry, a visit and a quote. GullySales works on the messages, the order and the record that keeps it going.

Scope, fee, reporting and term are agreed in writing after we have read your brief and spoken to you.

A handyman explains a cabinet repair to a homeowner

What follow up systems means

A follow-up system is the set routine for calling, messaging or emailing an enquiry more than once, since most buyers do not decide on the first conversation. GullySales sets the number and timing of follow-ups so an undecided buyer keeps hearing from you until they decide either way.

Last updated 14 Nov 2026.

For electricians

Where it usually goes wrong, and what we would do.

  • “A quote that gets no reply is not a refusal”

    A customer who got your list may be waiting for the designer, the landlord or a family member. A short, polite message asking if they have questions reopens a conversation that would have gone cold.

  • “The visit is the best moment to ask for a decision”

    While you are in the room, the customer sees the work and can ask about points and cable. Agreeing the next step there, such as the quote reaching them that evening, keeps the job moving.

  • “Fault customers need a different follow-up”

    After a repair, a call to check the supply is stable and a note on how to spot the problem again builds trust. It also gives you the moment to ask for a review.

  • “Repeated nudges turn into pressure”

    Repeating the same message annoys a household. One helpful addition each time, such as a photograph or an answer to a likely question, keeps the contact welcome.

What we do

What we deliver for electricians.

The work available for this need. We agree the deliverables and responsibilities for your engagement in writing.

  1. A message order for each stage

    Saved messages for after an enquiry, after a visit, after a quote and after a repair.

    Result: A set of messages ready for each stage.

  2. A visit-day habit

    Steps to take on site: agree the quote delivery, ask the preferred reply route and note the decision-maker.

    Result: A short checklist for the end of a visit.

  3. A quote reminder list

    A list showing each open quote and the next nudge due.

    Result: A list that shows which quotes need a message.

  4. A post-repair check message

    A note sent after a repair asking if the supply is steady, with the review link.

    Result: A saved message sent after each repair.

  5. A rule for when to stop

    A clear point after which you close the quote politely.

    Result: A written rule for closing a quote.

How the result is measured

  • Follow-up completion rate
  • Average number of follow-ups before close
  • Enquiries closed after repeat follow-up

Recorded as a baseline before work starts, so every later report has an honest comparison.

What to capture or send

The messages that follow a quote or a repair, and what each says.

Quote sent on WhatsApp
Send the itemised quote as a file with the date. State what is included and what is not.
A day after the visit, a short check
Ask if the fault has returned and whether the quote is clear. A question brings an answer where a nudge brings silence.
Reminder to a quiet customer
One message that repeats the quote and offers to answer a question. Include the date the rate holds if that is your practice.
Check after a repair
Ask whether the point works as expected. A customer who is asked can raise a problem with you before posting it.
Annual service note to a shop
Send a note near the date of last year's visit. The shop owner remembers the last electrician who asked.
Message to stop
Close the quote politely and note it as lost with the reason. Stops you chasing a customer who chose another person.

Who it is for

This is written for these electricians.

  • Home electricians doing repairs and fittings
  • Rewiring and new-point specialists for flats and independent houses
  • Electricians serving shops, clinics and small offices
  • Inverter, UPS and home battery installers
  • Fan, light and fitting installation teams
  • Earthing, MCB and DB box upgrade specialists
  • Electricians on annual maintenance for societies and landlords
  • Electricians who also take solar and EV charger point work

Before you decide

When this may not be the right fit.

  • You are too busy to open a chat, so a routine of messages would be skipped after the first few jobs.
  • You send quotes by voice call only and have no written quote, so there is nothing to follow up.
  • The customer has asked you not to message again, so any follow-up would be unwelcome.

Before you decide

Agree the work. Know how to judge it.

Follow-up systems for electricians: use these checks to prepare, choose the scope, and review what changes.

Bring the right evidence

Trace recent enquiries from arrival to the last recorded action. Include a won enquiry, an unsuitable one, and one that went quiet, with personal details removed for the initial discussion.

Make the scope clear

Agree who accepts each enquiry, what makes it qualified, and how ownership changes. Include a rule for missed replies and a clear reason for closing an enquiry.

Check the work in use

Pick an enquiry at random and ask the team to find its owner, latest conversation, and next action. Check that the record agrees with what actually happened.

Know when to change course

If no one has capacity to respond, assign that responsibility before buying more leads. Automation can support the owner, but it cannot replace an unresolved handover.

These are discussion points, not a fixed package. GullySales confirms the deliverables, responsibilities, fee, and term in writing after reading your brief and speaking with you.

Before we start

What to have ready before the work starts.

The records, access and decisions this work needs from electricians. Anything missing is noted in the written scope, with who will supply it.

The quotes you sent and never heard back on
A list of those quotes with dates, as far as you remember. They show where follow-up is missing. Without them, we cannot compare the routine with the past.
Your own words for a polite nudge
Two or three messages you have sent that felt right. We build from your voice. If none exist, we draft plainly and you reshape them. Pasted examples from your phone are enough, and we do not need them polished.
Agreement from customers to be contacted
A note of which customers are content to hear from you after a job. Messages go only to them. Without this, reminders wait until consent is recorded.
A rule on when to stop
Your own limit on how many nudges one quote gets before you stop. It prevents pressure. If you leave it open, we set a conservative stop and you adjust it.
Time set aside after each visit
A few minutes in which you or the helper write the next step into the record, straight after the visit while the details are fresh. The routine fails without it. If site days are packed, we shrink the routine to one message after the quote and add the others later.

How it works

How the follow up systems work runs

The work itself, in order. How an engagement starts, from your brief to a written scope, is set out on our method page.

  1. 1

    Read the last month of unanswered quotes

    We take the quotes you sent in chats and on paper over the last season and mark which were accepted, refused and which went silent. You tell us what you did after each, and who sent the nudge, if any. This shows where follow-up already happens, where it never does, and which customers went quiet after the visit instead of after the quote.

  2. 2

    Decide what counts as closed

    You tell us when you treat an enquiry as won, lost or dropped, and we write those three states into the record. A quote that was never answered needs a rule, and you set it. We also note who may close an enquiry, because a helper who marks a customer lost without telling you removes work you might still have won.

  3. 3

    Write the messages for each stage

    We draft a short message for after the first call, after the visit, after the quote and after a repair. Each uses your name and the job, and the repair message asks whether the point or fitting is still working as expected. You change any line that does not sound like you, and strike any that sounds like a sales script.

  4. 4

    Make the visit the moment to ask

    We agree one sentence you say before leaving a visit, asking when the customer will decide and how they prefer to be reached, by call or by message. You try it on the next real visits and tell us which customers answered plainly. The sentence is then fixed into the routine for your helper to say as well. We also note which customers prefer a call to a message.

  5. 5

    Test the order with your helper

    We run a few real or invented customers through the routine, with the helper sending the messages and writing the next step in the record. We watch for the point where the helper hesitates, since that is where the routine fails on a busy day. What exists is a routine that works when you are on a ladder.

  6. 6

    Compare replies with the quotes sent before

    After use, we count quotes answered, accepted and silent against what you recorded earlier, separating fault repairs from planned jobs because the two behave differently. You decide which message to shorten and where the stop rule belongs.

Where this fits

Three pieces of sales work, in this order.

This work sits inside sales process design, at stage 2, qualification. The audit comes before it, and sales management keeps it running.

  1. Step 1

    Sales audit

    Find where deals are being lost and what to fix first.

    Start here if you cannot say where orders are lost.

  2. Step 2 · you are here

    Sales process design

    One written way to sell, from first enquiry to repeat order.

    Start here if every salesperson sells differently.

  3. Step 3

    Sales management

    A target, a review routine and someone who owns the number.

    Start here if the team has targets and no routine.

Tell us what you need Your brief is read before we call. Scope, fee and term in writing.

FAQ

Questions owners ask before they call.

Not here? More answers, or ask on WhatsApp.

What should a follow-up say?
Something useful: an answer to a question, a photograph or a clear next step. A message that only asks if they have decided adds little.
How far should I take the follow-up?
Enough to be helpful and not more. Set a limit you are comfortable with, and close the quote once you reach it.
Can I automate this?
Some of it, such as a reminder of a due message. The message itself should still read as written by you, since the customer is dealing with a person.
How far should I take a follow-up on a quote?
Follow up once or twice, then close the quote. A customer who has not replied has decided or is unsure, and more messages read as pressure. Record the quote as lost with the reason if you learn it, so your next quote is better.
Should I follow up a customer who said no?
Not about that quote. A customer who refused has given an answer, and a second message makes you look desperate. You may keep them on the repeat-work list if they agreed to be contacted for later maintenance, and you may send one thank-you after the visit. Mark the quote as lost and note the reason if the customer gave one, since the reasons help the buyer persona later. We write the closing message so that it is polite and ends the thread, and you send it only where the relationship deserves it.
What if the customer replies at night?
Reply when you or your helper are next available and say so plainly in the saved reply, rather than promising an hour you cannot keep. A message that says you will respond on the next working morning is honest and keeps the customer. If a fault is urgent, the customer should have a number to call, which we place in the first reply. We do not set an auto-reply promising instant service. You decide which hours you will honestly cover and we write the message to match them.
How much does it cost?
There is no price list, because the work differs by business. The fee is scoped after we have read your brief and spoken to you, and put in writing before anything starts, split into our time, your media spend and production.
How long is the contract?
The term is agreed in writing after we have spoken, along with the fee and the reporting. It is never a default twelve months, and renewal is decided on the numbers against the baseline recorded at the start.
How soon will we see results?
It depends on the trade, the channel and what is already in place. After we have read your brief and spoken to you, we say what we would expect to move first and how it will be measured against the baseline. Nothing here is guaranteed.
Who will actually do the work?
The person you speak to before anything starts. We work from one office in Nagarbhavi, Bengaluru, with no account managers in between.

Your next practical step

Tell us what you are trying to grow, and we will read it before we call.

Eight short steps, mostly taps. Skip anything you would rather answer on the call.