Skip to content
GullySales

Water heater and geyser dealers · Follow up systems

Follow up the quote you sent, because the buyer is comparing three shops this week.

A follow-up system for a geyser dealer is a short routine for what happens after an enquiry, a quote, a visit and a fitting. GullySales writes the routine, the messages and the record so the buyer who went quiet is called once, politely, and the fitted customer is remembered at the descaling visit.

Scope, fee, reporting and term are agreed in writing after we have read your brief and spoken to you.

Editorial illustration for Lead response and follow-up

What follow up systems means

A follow-up system is the set routine for calling, messaging or emailing an enquiry more than once, since most buyers do not decide on the first conversation. GullySales sets the number and timing of follow-ups so an undecided buyer keeps hearing from you until they decide either way.

Last updated 14 Nov 2026.

For water heater and geyser dealers

Where it usually goes wrong, and what we would do.

  • “A quote goes out and nobody asks about it”

    The buyer compares three prices and the shop that calls back wins the conversation, not the cheapest.

  • “The fitted customer is never contacted again”

    A unit fitted in November is forgotten by February. The scale builds quietly, and the next call comes from a competitor's reminder.

  • “Follow-up reaches the wrong buyer in the wrong tone”

    A builder asked for a rate gets a cheerful household message. The tone and the sender must change with the buyer.

What we do

What we deliver for water heater and geyser dealers.

The work available for this need. We agree the deliverables and responsibilities for your engagement in writing.

  1. A follow-up map by stage

    A one-page list of what happens after an enquiry, a quote, a visit, a fitting and a service.

    Result: A map that the counter staff follow without being told.

  2. Message wording for each stage

    Short WhatsApp and call lines for the quote follow-up, the I will think about it reply and the post-fitting check.

    Result: Lines staff can use as written or adapt.

  3. A reminder list for service visits

    A filter from the purchase register for units that have run a season, limited to buyers who agreed.

    Result: A call list for the quiet weeks.

  4. A stop rule

    A written point after which the buyer is left alone, and how a no is recorded.

    Result: A rule that keeps follow-up polite.

How the result is measured

  • Follow-up completion rate
  • Average number of follow-ups before close
  • Enquiries closed after repeat follow-up

Recorded as a baseline before work starts, so every later report has an honest comparison.

Follow-up routine for this trade

What to do at each point in a geyser sale, who does it and what to record.

Enquiry not yet answered
The counter replies the same day on the channel used, with a question about bathroom and water. Record the time of the reply.
Quote sent
The person who quoted asks a day or two later whether the unit and fitting suit. Record the answer and any rival price named.
Visited but did not buy
The counter sends a short note thanking them and attaching the unit they looked at. Record what held them back.
I will think about it
Offer a fitting slot or a hold on the price for a stated period you can honour. Record the decision date.
After the fitting
The fitter or counter checks the next day that the unit works as expected. Record any issue and the review request.
Lapsed customer with an old unit
From the register, send a descaling or replacement note to those who agreed. Record the response and the next visit.

Who it is for

This is written for these water heater and geyser dealers.

  • Storage geyser retailers for homes and flats
  • Instant water heater and compact geyser sellers
  • Gas geyser dealers in cities with piped or cylinder LPG
  • Solar water heater dealers and installers
  • Heat pump and commercial water heating suppliers for hostels and hotels
  • Multi-brand electrical and bath fittings shops with a geyser counter
  • Builder and bulk-supply dealers
  • Authorised service and spare-part dealers

Before you decide

When this may not be the right fit.

  • You have no list of past quotes, so there is nothing yet to follow up and the first job is recording them.
  • Your counter team cannot take calls during the day, and a reminder system would send buyers to an unanswered phone.

Before you decide

Agree the work. Know how to judge it.

Follow-up systems for water heater and geyser dealers: use these checks to prepare, choose the scope, and review what changes.

Bring the right evidence

Trace recent enquiries from arrival to the last recorded action. Include a won enquiry, an unsuitable one, and one that went quiet, with personal details removed for the initial discussion.

Make the scope clear

Agree who accepts each enquiry, what makes it qualified, and how ownership changes. Include a rule for missed replies and a clear reason for closing an enquiry.

Check the work in use

Pick an enquiry at random and ask the team to find its owner, latest conversation, and next action. Check that the record agrees with what actually happened.

Know when to change course

If no one has capacity to respond, assign that responsibility before buying more leads. Automation can support the owner, but it cannot replace an unresolved handover.

These are discussion points, not a fixed package. GullySales confirms the deliverables, responsibilities, fee, and term in writing after reading your brief and speaking with you.

Before we start

What to have ready before the work starts.

The records, access and decisions this work needs from water heater and geyser dealers. Anything missing is noted in the written scope, with who will supply it.

The list of open quotations
Every quotation not yet answered, with the date and the buyer. It is the working list for the first round. If it does not exist, we build it from sent messages. Add the name of whoever sent each one and the person addressed, as a quote sent to a plumber instead of the household explains a silence.
Dates of fittings in the bill book
The date each unit was fitted. Reminders are built from them. Wrong dates produce reminders at the wrong time and annoy buyers. Include units sold from the display piece or without a bill, and mark them, because their reminders need a different approach.
A decision on who follows up
One person for calls and messages, with a stand-in. If the counter and the owner both assume the other will call, nobody does. Tell us also who steps in during festival rush, when the counter is full and calls are not returned.
A sample of messages you liked
A few lines you sent to buyers that you were happy with. We match your voice. If you have none, we write plainly and you correct what sounds unlike you. Even two or three messages let us match the length and warmth you use with households and with builders.
Reasons quotations were lost
Any note on why quotes failed: price, a rival, a delay in delivery, a change of mind. These guide the wording. If none exist, we ask the counter and mark it as recollection. Even half a dozen remembered reasons let us write the second message of each stage to meet the real objection, such as delivery or price. Where a reason is missing we leave a blank rather than guess, and the message for that stage stays general.

How it works

How the follow up systems work runs

The work itself, in order. How an engagement starts, from your brief to a written scope, is set out on our method page.

  1. 1

    Follow three quotes that went quiet

    We pick three quotations that received no answer and trace each: who sent it, who was called, what was said and what was noted. You recall what the buyer said. This shows where the chain breaks in your shop, whether at the first call after sending, at the point where a builder compared rates, or when the household went to another lane.

  2. 2

    Draw the stages from call to service visit

    With your counter staff we draw the stages: enquiry, visit, quote, order, fitting, first week of use, service reminder. At each stage we mark who is responsible and what the buyer expects to hear. You correct stages that do not match how the shop works. The map is one page the whole counter can read. We mark the stages where a household decides alone and those where a second person must approve, since the message differs.

  3. 3

    Write the messages for a household and a builder

    We draft the call script and the WhatsApp wording for each stage, in the voice of your shop, separately for a household, a plumber and a builder. You change anything you would not say. Each message asks one thing and offers one next step, so that it does not read like a bulk circular.

  4. 4

    Agree the stop rule with the owner

    The owner decides how many tries a quotation gets and what ends the chase: a refusal, a purchase elsewhere, silence after the agreed attempts. We write it down. Without a stop rule staff either chase forever or drop quotes at random, and buyers are annoyed either way.

  5. 5

    List the fitted units due a service note

    From your bill book we list units fitted some time ago and set a reminder for the counter to offer a service visit or a replacement. Your counter checks a sample against the paper. The list uses the dates you give, so a wrong date makes a wrong reminder. Units sold with a bundled fitting are listed apart from those fitted later, because the first reminder for each is worded differently.

  6. 6

    Read the replies against the earlier silence

    After the routine has run, we count quotations answered, visits booked and service calls started, and compare them with the figures kept for the earlier quiet period. You say which messages got replies and which were ignored. We rewrite the weak ones. We promise no rise in sales, only a record of what happened after each message.

Where this fits

Three pieces of sales work, in this order.

This work sits inside sales process design, at stage 2, qualification. The audit comes before it, and sales management keeps it running.

  1. Step 1

    Sales audit

    Find where deals are being lost and what to fix first.

    Start here if you cannot say where orders are lost.

  2. Step 2 · you are here

    Sales process design

    One written way to sell, from first enquiry to repeat order.

    Start here if every salesperson sells differently.

  3. Step 3

    Sales management

    A target, a review routine and someone who owns the number.

    Start here if the team has targets and no routine.

Tell us what you need Your brief is read before we call. Scope, fee and term in writing.

FAQ

Questions owners ask before they call.

Not here? More answers, or ask on WhatsApp.

Will follow-ups annoy buyers?
Not when each carries something useful, such as the fitting date or a note on the model they asked about. Send one message with a reason and then wait for the reply.
Who should own the follow-up?
One named person at the counter, with the owner reviewing the list. If it belongs to everyone, the quote nobody sent sits until the buyer buys elsewhere.
Which follow-up works for a geyser quote: call or WhatsApp?
Answer through the route the buyer chose to contact you. A WhatsApp enquirer wants a message with the quote attached, while a caller at the shop expects a call, and a contractor wants an email or a PDF.
When should we stop following up?
After a clear no, or after two unanswered messages with a reason in each. Record the outcome and the stated reason so you learn why buyers choose elsewhere.
Will repeated messages irritate a household buyer?
Not if each message adds something and asks for one thing. A buyer who gets three identical reminders stops reading, while one who gets a note offering to check the capacity, then a call after a few days, sees a shop that cares. We write for the buyer's own pace and the stop rule means nobody is chased after a clear no. A household buying once should be asked once more, politely, and then left alone.
Which works better for a geyser quote, a call or WhatsApp?
Send the quotation by WhatsApp because the buyer can keep it and show the family. Follow with a call if there is no reply, since a voice settles questions about capacity faster than text. For a builder, a written message first and a call to the site engineer later suits the way they work. Record which route each buyer prefers and use it next time.
How much does it cost?
There is no price list, because the work differs by business. The fee is scoped after we have read your brief and spoken to you, and put in writing before anything starts, split into our time, your media spend and production.
How long is the contract?
The term is agreed in writing after we have spoken, along with the fee and the reporting. It is never a default twelve months, and renewal is decided on the numbers against the baseline recorded at the start.
How soon will we see results?
It depends on the trade, the channel and what is already in place. After we have read your brief and spoken to you, we say what we would expect to move first and how it will be measured against the baseline. Nothing here is guaranteed.
Who will actually do the work?
The person you speak to before anything starts. We work from one office in Nagarbhavi, Bengaluru, with no account managers in between.

Your next practical step

Tell us what you are trying to grow, and we will read it before we call.

Eight short steps, mostly taps. Skip anything you would rather answer on the call.